Mitsubishi FX2N-10GM - Page 174

FX Series Positioning Controllers Program format 5
5-64
List of specification of number of digits
The I/Os shown in the table below are required for the SEGL instruction in accordance with the
number of digits to be displayed.
In the FX
2N
-10GM, only K1 or K2 can be set when a positive value is output, and only K17 can
be set when a negative and positive values are output.
Table 5.20: List of specification of number of digits
Number of
digits to be
read
Reading a positive value Reading a negative value
Number of
data registers
occupied
Number of
outputs
“n1” set value
Number of
outputs
“n1” set value
15K16K17
1
26K27K18
37K38K19
48K49K20
59K510K21
2
610K611K22
711K712K23
812K813K24