Mitsubishi L2E Service Manual

77 / 155
Service Manual Mitsubishi L-Series diesel engines
Version 08/2004
CRANKSHAFT
ENGLISH
ENGINE MAIN PARTS
16.5 Installation
When installing the crankshaft, pay attention to the
notes given in the figure below.
Place cap flush with the
end face of cylinder block.
Round end down
Side seals coated with sealant
(THREE-BOND 1212)
Thrust bearing only for No. 2 cap
Cap tightening torque:
49.0 to 53.9 N·m
(5.0 to 5.5 kgf·m)
[36.17 to 39.78 lbf·ft]
Crankshaft end play:
0.05 to 0.175 mm
[0.0020 to 0.0069 in.]
Direction of
cap installation
Front
Figure 82 Installation of crankshaft

Mitsubishi L2E Specifications

General

Engine Model	L2E
Number of Cylinders	2
Starting System	Electric starter
Lubrication System	Forced lubrication by trochoid pump
Cooling System	Water-cooled