Methods of creating stitching data
3. Changing the input method
* The movement amount will be cleared.
* The code will change to "SEW".
* If the stitching type is not "ARC
INPUT", (if the type is "LINEAR
INPUT"), press and change the
type.
(The currently set stitching type will be
displayed on the key.)
4. Designating arc input
* Press and then press .
* The system will return to the arrow
input screen.
5. Setting B point and C point
* Press the arrow mark key to move to
point B.
* The movement amount can be
confirmed.
* Press to determine point B.
* Press the arrow mark key to move to
point C.
* Press and set the arc input.
To Next Page
Loading...
Need help?
General
