Methods of creating stitching data
[9]-21
5. Inputting the return/end code
* Press .
(Data on feed data to the home position
and the end code will be created.)
* A prompt for home position return will
appear.
Press .
* A message indicating that the data is
being created will appear, and then
the Standard screen will reappear.
6.Confirming the data
* Confirm the data.
Press the jog keys ( ),
so the sewing machine movement can
be confirmed. (Even if the data input
has not been completed, if the data
input last has been set, the movement
can be confirmed in the same
manner.)
* If the confirmed data is correct, save
the data. (Refer to [5] Reading, writing
and erasing data (floppy disk) and [6]
Reading, writing and erasing data
(internal memory).)
The clamp will automatically return to
the home position. Take care when the
needle is lowered, etc.
* If the data must be modified, refer to
section [12] Modification mode
Modifying the stitching data.
To Next Page
Loading...
Need help?
General
