Monitor MB206 - Configuration Options

15Configuration Options
Configuration Options
The terminals are extremely flexible due to the vast number of configuration options. Some of these
options are sent from Supervisor Net, but other options must currently be set on the terminal itself.
This is a list of all configuration options, and whether they are found Internally (Set through the
terminal) or Externally (Sent from Supervisor Net). In some situations the options are found in both
places, in which case the setting from Supervisor over-rides the setting set in the terminal.
These options are explained in more detail in further sections.
Option
Source
Terminal ID
Internal
Main Serial Port Baud Rate
Both
Main Serial Port Parity
Internal
Main Serial Port Device
Internal
Ignore Frame Errors on Main
Serial Port
Internal
Aux Serial Port Baud Rate
Both
Aux Serial Port Parity
Internal
Aux Serial Port Device
Internal
Ignore Frame Errors on Aux Serial
Port
Internal
RTS Delay Time
Internal
Poll before Acknowledge Period
Internal
Enable TCP-IP Communications
Internal
Terminal IP Address
Internal
Subnet Mask
Internal
Server IP Address
Internal
Gateway Address
Internal
TCP-IP Port
Internal
Enable use of DHCP
Internal
TCP-IP Filters
Internal
ARP flush time
Internal
Alter 'Reset' Password
Both
Alter 'Admin' Password
Both
Run Mode
Both
Clear statistics
Internal (And IP Terminal Utility)
Enable use of PINs
Internal
'Monitor Card' Prefix
Internal