53Version 6 Terminal Menu System Options
0 Alarms: 0% of 20 - The number of alarms in memory. Alarms will only be stored in memory if
communications to Supervisor Net are not possible.
5 Card Status
A read-only mirror view of the Card Setup menu.
Card Type: Current = Standard
Wiegand Reader: Current = Disabled - this option can not be directly altered. It is determined by
the Card Type specified.
HID Convert: Current = Disabled
Allow Set No PIN: Current = Enabled
Ignore Cards: Current = Disabled
Mon Card Prefix: Current = 600599
Card Prefix 2: Current =
Card Offset 2:Current 0
Card Length 2: Current = 0
Card Prefix 3: Current =
Card Offset 3: Current 0
Card Length 3: Current = 0
Card Prefix 4:Current =
Card Offset 4: Current 0
Card Length 4: Current = 0
Hex Card Number: Current = Disabled
6 Copier Status
A read-only view of the copier configuration.
Copy Make: Now = Standard
Copy Model:Now = Standard
Exact Timing: Current = Yes - Only appears if Model is set to Multi-pulse
Copier Mode is: Single Pulse
Paper Feed Time: 5.0 seconds
1st Copy Timeout: 0 minutes
7 eCopy Status
Displays the current settings for eCopy mode. This menu item appears regardless of whether
eCopy is enabled or not.
Enable eCopy: Current = Disabled
eCopy MultiDisb Name: Current = eCopy
8 Konica Copier (Visible when Konica mode Enabled)
These options are only visible when the copier make is set to Konica.
For Vendor Mode 1
Vendor Mode: Current = Mode 1 - Vendor Mode 1
Polls Received: No - When the terminal is connected to the copier, the copier polls the
terminal every 10ms. No polls from the copier means that the copier is
switched off or there is a problem with the interface cable.
Colour Mode: Full Colour - Detection of Colour or B&W from the copier
Current Size: 0mm x 0mm - Paper size being used in the copier
Machine Status: Not Ready - Detection of whether the copier is ready to copy or not
Panel Copies: 0 - How many copies of the document the user has dialed up on the display
To Next Page
Loading...