Configuration Options22
Parity Mask1 : EXXXXXXXXXXXX (Even Parity checked on bits 1 -
12)
Parity Mask2: XXXXXXXXXXXXO (Odd Parity checked on bits 13 - 24)
Card Number Mask: NNNNNNNNNNNNNNNNNNNNNNNN (N=Card Number)
The 24 bits of data are grouped into six groups of four bits.
Each of the four bits are turned into ascii characters.
This format has no Facility code, therefore all bits are turned into a card number.
The bytes are converted from hexadecimal to decimal, unless a hex number is required.
Note: Unlike the Version 5 Terminal, there is no separate option to change the electrical input of the
card reader header between clock and data input and Weigand format input. Instead, this is
determined automatically by the type of card chosen in this menu. This is how the card reader
header will be configured depending on whether a Weigand or Clock and Data format card is
selected:
Pin Function (Clock and Data) Function (Weigand)
1 GND GND
2 +5v +5v
3 Card Detect Data0
4 Clock Data1
5 Data N/C
Clear Host?
Setup Tcp/Ip
The terminal is capable of communicating with the Supervisor Net server by resolving the server's
machine or Host name to an IP address instead of directly specifying a fixed IP address.
This option will clear the host name from the terminal in the event that you wish to fall back to using
a fixed IP address.
The host name can be set again using the IP Terminal Utility.
Clear Statistics
General Setup
Clears the statistics that are stored in the terminal's non-volatile memory.
Clr Restriction 1 - 10
Setup Clr Restrictions
Sets the restrictions to use colour based upon the particular price code. As there are 10 possible
price codes in Supervisor Net, there is one setting per price code.
Colour Steering Line
Setup Clr Restrictions
When restricting a user's use of colour on an MFD, this option tells the terminal what steering line is
associated with colour status.
To Next Page
Loading...