55Version 6 Terminal Menu System Options
10 Clr Restrictions
Shows the status of the Colour restrictions settings. Photocopying in Colour can be restricted based
upon a user's price code.
Colour Steering Line: Current = 2 - Tells the terminal which steering line the colour status from the
copier is connected to.
Clr Restriction 1: Disabled - This item, and the ones following it determine whether users with this
price code can copy in colour.
Clr Restriction 2: Disabled
Clr Restriction 3:Disabled
Clr Restriction 4: Disabled
Clr Restriction 5:Disabled
Clr Restriction 6: Disabled
Clr Restriction 7:Disabled
Clr Restriction 8: Disabled
Clr Restriction 9:Disabled
Clr Restriction 10: Disabled
11 Term Statistics (since 28/8/2000)
Displays a list of terminal statistics, collected since the specified date. These statistics can be
deleted through the Clear Statistics option in the terminal General Setup menu, or using the IP
Terminal Utility.
Commands - Messages sent to the terminal from the Supervisor Net Terminal Server
Negative Acks - This is sent when the Terminal Server receives a bad message. It requests that the
data be sent again
Comms Flushed - No longer used. Used for older serial based communications
Dup Comms - Part of the terminal's setup was received twice during a request setup
Timeouts - The terminal sent a message and did not receive a reply. The message was re-
transmitted
Comms Logic Errors - An unknown error has occured
Poll before Ack - No longer used. Used for older serial based communications
Lost Ack/Nak - Similar to a timeout. The terminal sent an ACK or NAK and received no reply
Lost Display Msgs - The message buffer was flushed because it was full. Some messages weren't
displayed
Keystrokes - How many key-presses have occurred
Cards Read - Total number of successful card-swipes
Bad Cards - Total number of Unsuccessful card-swipes
Transactions - Total number of sessions with a successful transaction unload
Powerups - How many times the terminal has been turned on from an off state
Up Time - Number of minutes the terminal has been running since last stats reset
Flash Changes - Number of times the terminal's firmware has been upgraded
Dropped Packets - IP stack messages dropped. Often because the buffer is full
Buffers Full - The IP buffer is full, further comms is not possible until the buffer empties
12 Terminal Config
This menu shows a list of non-user editable terminal configuration parameters. These are set in the
factory when the terminal is manufactured.
ROM Size - The ROM chip capacity
RAM Size - The terminal's RAM capacity
EEprom Size - The capacity of the EEprom which stores the terminal profile
Model Number - An internal reference to the type of terminal it is
To Next Page
Loading...