25Configuration Options
Hex Card Number
Card Setup
When enabled this will convert the card swipe number into a hexadecimal value before attempting to
validate the account.
HID Convert
Card Setup
Converts a number from an HID card into its Hot Stamp equivalent before validating the account.
The Hot Stamp is the number printed on the card. This feature makes it easy to insert new card
numbers into the system, as the administrator can simply read the card number off the card.
The HID Convert will only work when the HID Prefix matches the prefix of the number read off the
card. Standard swipe cards, etc, will be read as normal.
HID Card Prefix
The prefix read off the card must match this prefix, otherwise an HID convert is not performed.
Use Facility Code
The facility code is usually stripped off the card number during an HID convert. Enabling this
option will include the facility code in the output of the card number.
Card Size 4-5
Sets the output length of the hot stamp card number to either 4 or 5 characters long.
Hour for Reboot
General Setup
Used in conjunction with Minute for Reboot.
Forces the terminal to reboot on a set hour of the day.
Hours to Reboot
General Setup
Forces the terminal to reboot every X hours.
Ignore Cards
Card Setup
A terminal will usually exit a session if it detects another card swipe. This setting will turn this feature
off.
To Next Page
Loading...