Configuration Options42
Allow Cash Out
These functions only work with Terminal firmware that supports Cash Register interfacing. This
option, when ticked, allows money to be deducted from an account at a Terminal.
Receipt Printing Enabled
Turns receipt printing on or off for an autoloader with that functionality.
Encrypt Card Number
When the receipt is printed, instead of putting the actual primary number of the user on the receipt,
their number will appear in an encrypted form. This prevents another user from discovering the
primary number and using it on a keyboard of a terminal to gain access to the other user’s account.
This encrypted number can be decrypted by an administrator to help a user should they have an
issue with their transaction at the autoloader. When searching for the encrypted number in
Administrator, tick the box labelled Encrypted.
Coins Accepted
A list of coin types that can be enabled or disabled in the autoloader. You may not want to accept
the smallest denominations as they sometimes jam the coin acceptors and cost too much for a
security company to collect.
Fax/Phone Tab
Enable Line Interface
Tells the terminal to look for a Line Interface Unit on the Aux port.
Outside Line
Defines the number dialled to get an outside line so that Supervisor can ignore it when calculating
the call rate.
Emergency
Any emergency numbers that the LIU must allow to be made regardless of balance or valid
session.
Entry Time
This is the maximum time between digits when manually dialling a number on a Fax or Phone. This
can be 1-9 seconds.
Attempts
How many dialling attempts can be made before the terminal deletes the session code from memory
and does not allow any more redials.
Timeout
This is the time, in minutes, the fax is allowed to try to contact a number before giving up. The
timer started after the first dial attempt. The value can be 0-59 minutes. Zero means the fax or
phone has unlimited time to attempt to connect.
Holding Time
This is the time the Terminal will hold the Fax Session ID before deleting it from its list in memory.
This only applies to Modes 1 and 2 of Fax Control. This can be 0-12 hours.
To Next Page
Loading...