Monitor MB206 - Alter Admin Password; Alter Reset Password; Alter IP Util Port; Auto Accept Limit

Configuration Options18
Alter 'Admin' Password
General Setup
Sets the password for Admin access to the terminal's menus.
The Admin password gives a limited sub-set of access, including:
- View Files
- Miscellaneous
Alter 'Reset' Password
General Setup
Password to grant access to the reset menu functions, which include all password protected areas
in the terminal.
Alter IP Util Port
Setup Tcp/Ip
Changes the port that the terminal uses when communicating with the IP Terminal utility.
the prime reason for this option is so that terminals behind a firewall can be contacted by the IP
Terminal Utility by configuring the firewall to use network address translation (NAT).
If all the terminals are listening on different ports, the firewall can be configured to direct outside
requests to those port numbers to the internal IP addresses and ports for the terminals.
To use this function, the ports must also be defined in the IP Terminal Utility.
Auto Accept Limit
General Setup
Specifies how much each user can spend in a single session when the terminal is in Auto Accept
mode. Note that this is per session only. The user can open another session and spend up to the
same value again.
Auto Print Release
Turning this function on will force the terminal to release all print jobs for this user from the print
queue as soon as a user validation occurs. This can speed up the throughput of users on the print
release terminal by not allowing them to choose individual jobs to release.
Auto Sense Auto Accept
General Setup
The terminal will automatically enter Auto Accept mode when it can no longer communicate with the
server but can still detect a network connection.
As soon as the server is detected, the terminal will exit Auto Accept mode and unload any stored
transactions.