Configuration Options28
3. DSP840 - External display unit for point of sale
4. BMR - Barcode and Magnetic Card reader. The terminal strips the ; and ? characters off the
card number that comes from the reader. The baud rate is fixed to 9600. Developed against
model BMR-R-33.
5. LIU - Line Interface Unit. Used for page counting from fax machines or cutting a telephone line
when charging for time.
6. Serial Reader - Generic serial card reader. Baud rate is set in the normal com port settings
menu.
7. Remote - The terminal is attached to a PC for reasons such as print release etc.
8. Printer - Support for a receipt printer.
9. Boom - Used with a boom gate. Communicates with a boom gate controller via a serial protocol.
10. Internet - Used with an LIU unit to enable and disable an external device such as a keyboard or
mouse.
11. Sharp - Support for Sharp UP700 Cash register. The cash register will use the terminal as a
source of funds for the user.
12. Copier - The terminal is connected to a Xerox or Konica Minolta copier via the main serial port.
Main Serial Port Parity
Setup Comms
Sets the parity of the main serial port. Available options are:
Even
Odd
None
Max Balance
General Setup
Defines the user's maximum balance. If the user is adding funds to their account through a terminal,
it will not allow their balance to exceed this limit.
Message Scroll Delay
General Setup
When a message is too large to fit on a single line of a display, the first part of the message will
appear on the screen for this amount of time before it starts to scroll through the rest of the
message.
Message Scroll Speed
General Setup
When a message is scrolling across the screen, the speed it scrolls is set by this option.
Micros Interface
General Setup
Enables the terminal to be connected to a Micros point of sale unit. Please check with support
before using, as this option isn't available n all versions of Supervisor Net.
To Next Page
Loading...