Configuration Options46
students are limited in how many copies they can do on an express copier but staff are not
restricted.
Variable Type Timed
Enables the charging for services based upon time rather than quantity. There are four options
available:
1) Unused – Default setting if Variable Type Count is exclusively required.
2) Timed Pulse – Begins timing when a pulse appears on the Count opto-coupler, and stops timing
when a second pulse is detected.
3) Timed Now – The amount of time the session is active will be calculated and charged for; from
the time the main relay opens until the time it closes.
4) Timed Fax/Phone – Supervisor will derive the chargeable time from an LIU unit connected one of
the terminal's serial ports.
Limit Run Time
The same concept as Limit Run Count, but you can specify a time limit for a session instead of a
count quantity. When this item is selected, a ‘Length’ option box will appear. This is length in
seconds and is configurable from 1 to 10,000.
Unit Duration
The chargeable time duration in seconds.
Minimum Charge
A minimum time charge can be applied regardless of how short the actual duration of the session
was.
Rounding Type
Specifies how to round the time of the session. There are three options:
1) Up – Round up to the nearest unit
2) Down – Round down to the nearest unit
3) Round – Round up if over half a unit or round down if under half a unit.
GST Rated
Records that tax is included in the value of the transaction for reporting purposes. By default
Supervisor Net has the Tax name set to GST (New Zealand/Australia convention). The Tax Rate is
set in the system Country.ini and the name of the TAX is set in the System Configuration database.
Send To Terminal
When selected, the disbursement will be sent to the local memory of the terminal. This is required
when AutoAccept is used on a terminal that uses multiple disbursements. It’s interesting to note that
having the disbursement residing locally in the terminal’s memory also speeds up the initial opening
of a session, however, you must remember to send the setup back down to the terminals if the
pricing in the disbursement ever changes.
Price Multipliers Tab
Price Code Multipliers
Price Code Multipliers are used to calculate prices for transactions. These can be used to setup
discounts if the multiplier is set less than 1 (.95 for example). The Multipliers can be set between -
99.9999 and 99.9999. The actual charge is calculated as follows: ACTUAL CHARGE =
To Next Page
Loading...