Configuration Options20
Card Length 2 - 4
Card Setup
Defines what card length is to be used based upon the corresponding Card Prefix.
The card length determines how many characters are to be read off the card. E.g:
Full Card Number: 60048912345678
Card Length: 6
Card Number read: 600489
This may also be used in conjunction with Card Offset to give precise card reading. E.g.:
Full Card Number: 60048912345678
Card Offset: 6
Card Length: 4
Card Number Read: 1234
Card Offset 2 - 4
Card Setup
Defines what card offset is to be used based upon the corresponding Card Prefix.
An offset defines now many numbers to ignore off the front of a card. E.g:
Full Card Number: 60048912345678
Card Offset: 6
Card Number read: 12345678
This may also be used in conjunction with Card Length to give precise card reading. E.g.:
Full Card Number: 60048912345678
Card Offset: 6
Card Length: 4
Card Number Read: 1234
Car Park Full
General Setup
When enabled, the terminal will take note of the state of steering line 1 (Opto input 2). When the line
goes high, the message 'Car Park Full' will appear on the terminal display and any card swipes will
be ignored.
This is used in conjunction with a boom gate system.
Card Prefix 2 - 4
Card Setup
Allows you to configure up to 3 additional card prefixes to use on the site. The terminal can apply
separate Card Offsets and Card Lengths based upon the card prefix encountered.
See also Card Offset 2 - 4 and Card Length 2 - 4
To Next Page
Loading...