EasyManua.ls Logo

Monitor MB206 - Autoloader;Cash Register Tab

Default Icon
98 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
41Configuration Options
using a parity bit, the parity bit is usually added at the end of a byte and there is a comparison
made between the original and received byte by counting the set bits (1's). You can have odd or
even parity, but it can’t correct the errors - only check for them.
Monitor Cards Only
This option, when ticked, will only allow Cards to be validated that match the Monitor Card Prefix.
The Monitor Card Prefix can be altered in the Terminal Configuration Menu.
Auto Suffix Enabled
When a user swipes their card at a terminal, a suffix can automatically be appended to the end of
their card number before being verified against the primary database. This may be required where
a specific account is to be used in a specific location or purpose, e.g. a tuck shop terminal.
Suffix
This is the suffix that will be appended to the primary number if Auto Suffix is enabled.
Prompt for Suffix 'Enabled'
The user can be prompted to append a suffix manually to their primary number.
Prompt for Suffix 'Prompt'
The prompt the users sees when they are prompted to enter a suffix.
Autoloader/Cash Register Tab
Initial Balance
The Initial Balance is printed on receipts when an Autoloader Buy Card transaction is performed.
This amount should be configured to match the amount that has been added to cards, in advance,
that are dispensed from the Autoloaders.
Message Delay
This is the time, in seconds, between dispensing a card and displaying the next message on the
Autoloader display panel.
One Shot Buy
This option, when ticked, allows a single note or a single coin to buy a card. After buying the card,
the autoloader will end the session.
One Shot Add
After a user swipes their card to initiate the session, they can put one coin or note in the
autoloader before it will end the session.
Stop On Error
This option, when ticked, will force an end to a session if the Autoloader jams or malfunctions during
the session.
Allow Cash In
These functions only work with Terminal firmware that supports Cash Register interfacing. This
option, when ticked, allows money to be added to an account at a Terminal.

Table of Contents