Version 6 Terminal Menu System Options60
15 Card Length 3
16 Card Prefix 4
17 Card Offset 4
18 Card Length 4
19 Hex Card Number
6 Copier Setup
This menu contains all the parameters for setting the copier make and model attached to the
terminal. It also contains the configuration required to set up special modes such as copy type
learning mode.
1 Change Copy Make: Current = Standard
2 Exact Timing: Current = Yes - Note: This option is only visible if Copy Make = Standard, Model
= Multi-Pulse
3 Input Count Mode: Current = Single Pulse
4 Multi-pulse Learn Mode - Note: This option is only visible if Copy Make = Standard, Model =
Multi-Pulse
5 Paper Feed Time: Current = 5.0
6 1st Copy Timeout: Current = 0 (0-99)
7 Konica Setup - Note: This option is only visible if Copier Make is set to Konica.
8 Xerox Setup - Note: This option is only visible if Copier Make is set to Xerox.
7 eCopy Setup
This menu contains the items required for the interface between the terminal and eCopy. eCopy is
a third party application used for tracking activity on certain makes and models of copiers an
printers. See the associated knowledgebase article for more information on the configuration of this
feature.
1 Enable eCopy: Current = Disabled
2 eCopy MultiDisb Name: Current = eCopy
8 Clr Restrictions
Photocopying in Colour can be restricted based upon a user's price code.
1 Colour Steering Line: Current = 2 - Tells the terminal which steering line the colour status from
the copier is connected to.
2 Clr Restriction 1: Disabled - This item, and the ones following it determine whether users with
this price code can copy in colour.
3 Clr Restriction 2:Disabled
4 Clr Restriction 3: Disabled
5 Clr Restriction 4:Disabled
6 Clr Restriction 5:Disabled
7 Clr Restriction 6: Disabled
8 Clr Restriction 7: Disabled
9 Clr Restriction 8:Disabled
10 Clr Restriction 9:Disabled
11 Clr Restriction 10: Disabled
9 Request Setup
Forces the terminal to request the setup parameters be sent down from Supervisor Net. Any settings
sent from Supervisor will over-write the same settings if they are also found via the terminal
configuration menus.
To Next Page
Loading...