Configuration Options30
Print Two Receipts
General Setup
Forces the terminal to print two copies of a receipt. This is useful in a point of sale environment
where one receipt is put in the cash drawer, and the other receipt is handed to the customer.
RTS Delay Time
Setup Comms
Supported only on the Main serial port. A delay in milliseconds of sending the RTS signal after
receiving a CTS signal from an attached device.
Run Mode
General Setup
Sets the run mode of the terminal. Note: If this setting is changed in the menu of the terminal, it will
be over-ridden by the setup received from Supervisor Net 4.0 and above.
Available run modes are:
Standard Mode - The terminal will behave normally
Fax Mode - Enables the LIU (Line interface unit) functions of the terminal. This setting assumes
that an LIU unit has been connected to the Main or AUX serial port.
Remote Mode - The terminal will look at the serial ports for remote devices connected, such as a
print release station computer.
Multi Disb Mode - Enables the use of multiple disbursements during a session. The user is
prompted at the beginning of the session as to which function they wish to use.
Serial Mode - Serial communications to devices such as a serial card reader.
Retail Mode - Enables the special retail functions of the terminal. An ACT8xx external keypad and
a barcode scanner can be connected to the terminal for use in a retail environment.
Screen Flip time
General Setup
Some messages will alternate on the terminal screen instead of scrolling. This setting will determine
how long each message appears on the screen.
Show Counts
Changes the session prompt to not include any information about balance or DR/CR. It will make a
user's session look like an unlimited credit session.
Subnet Mask
Setup Tcp/Ip
The Subnet Mask of the network segment that the terminal is connected to. This setting is ignored if
the terminal is configured to use DHCP.
To Next Page
Loading...