43Configuration Options
Unload on Line Reversal
This option, when ticked, will make the Terminal only unload a transaction if it detects Line Reversal.
Line Reversal is used to confirm that a Fax or Phone call has been answered. The Monitor Line
Interface Unit (LIU) simulates Line Reversal for Fax calls. For normal Phone calls the Line Reversal
detection will only work if phone line supports Line Reversal. The Telephone Line Provider must
specifically supply Line Reversal for the LIU to detect it.
Charge on Line Reversal
If the terminal detects line reversal, (An old fashioned way that telephone networks used to indicate
that a device had picked up at the other end), it will start charging.
Prompt for Pages
Instead of automatically counting pages as they are transmitted, the user will be prompted for how
many pages they are sending. This is usually for a PRO environment where clients are being
charged for the services.
Passwords Tab
Debug Mode Enabled
The Debug Mode allows an authorised user to access the View Files and Miscellaneous menus.
Debug Mode Password
The password required to enter Debug Mode.
Terminal Reset Enabled
Allows an administrator or technician to enter the terminal configuration section of the terminal
(Supv-2).
Terminal Reset Password
When entering the terminal configuration section of the terminal, this is the password that must be
entered. Note: If this is left blank, a dongle plugged into the Aux port of the terminal will be required
to enter this mode. It is highly recommended that this is left as six dots (……).
Allow Pause Mode
This option is not currently supported.
Auto Accept
A user can still swipe their card or enter their primary and/or secondary number even if the terminal
cannot currently communicate with the server. This mode must be enabled by entering a password
at the initial prompt. The password can be the number encoded on a magnetic swipe card. Any
transaction data recorded during this session will be unloaded back to the server once
communications have been established again.
Password
As above, the password used to turn on Auto Accept when the terminal cannot communicate with
the server.
Primary Mask
During Auto Accept mode, a mask can be defined to help ensure that a valid Primary number has
been entered. The mask format is the same as used by the ‘Primary Extra Input Mask’.
To Next Page
Loading...