23Configuration Options
Copier Make
Copier Setup
Determines what kind of photocopier the terminal is connected to. The following options are
possible:
Standard
A standard analogue-input copier connected to the opto-couplers of the terminal
Konica
Supports the Vendor mode 1 and Vendor Mode 2 protocols when connected to a Konica copier via
the main serial port. See the Interface Cables section for details on how this is achieved.
Additional options when this mode is enabled are:
1 Select Model Vendor 1 - Enables Vendor Mode 1
2 Select Model Vendor 2 - Enables Vendor Mode 2
Xerox
Supports the various versions of Xerox serial interface for direct connection to a Xerox copier via
the main serial port. See the Interface Cables section for details on how this is achieved.
Turning this on will require choosing one of the following:
1 Type 1 - Older copiers have a slightly different communication protocol to the newer range. These
are called Type 1 copiers.
2 Type 2 - For newer copiers
Canon
A special Canon mode for IRC3100 and IRC3200 colour copiers. Choosing this option will require
setting one of the following:
1 Select Model IRC3100 - Special mode for the IRC3100 copier
2 Select Model IRC3200 - Special mode for the IRC3200 copier
Choosing 2 will also give you the option of enabling Canon Low Funds mode. In this mode, the
user will be allowed to remain in session even if they don't have enough money for the most
expensive disbursement extension, however as soon as they don't have enough for the cheapest,
the session will end as normal. This is because the IRC3200 begins its session in colour mode, and
some users would just want to do black and white copies. There is always the opportunity for the
user to go into negative balance if this option is used, as the user may choose to do a colour copy
when they don't have the necessary funds.
Credit Items
Turning on Credit Items will allow the operator to credit users for unwanted goods during a Retail
Terminal session. They do this by pressing the Function button and then scanning the unwanted
item.
Display Balance
General Setup
When enabled, the terminal will display the user's balance on the screen during a session instead of
the normal Debit/Credit values.
To Next Page
Loading...