Monitor MB206 - Konica Setup; Main Serial Port Baud Rate; Main Serial Port Device

27Configuration Options
The disbursement extensions will therefore be set up in this way:
Extension # Name
1 A4 B&W
2 A3 B&W
3 A4 Colour
4 A3 Colour
5 A4 B&W Duplex
6 A3 B&W Duplex
7 A4 Colour Duplex
8 A3 Colour Duplex
Konica Setup
Copier Setup
This menu item only appears when Copier Make is set to Konica. The available options are:
1. Metric Paper - If set to YES, Metric paper sizes are assumed. When set to NO, US/Imperial
sizes are assumed.
2. DelayTime - Only set to something other than the default if instructed by Monitor. This is the
amount of time the terminal waits after receiving a request from the copier before
replying.
3. Black/White only - If enabled, the terminal will only allow black and white copying on the device.
4. Limited Disbs - Limits the number of disbursement extensions to 4. These are usually A4 B&W,
A4 Colour, A3 B&W, A3 Colour. Any other detected sizes are approximated to
the nearest of these four.
Main Serial Port Baud Rate
Setup Comms
Sets the baud rate of the main serial port. The available speeds are:
150
300
600
1200
2400
4800
9600
19200
Main Serial Port Device
Setup Comms
Sets which device is attached to the Main serial port.
Current devices are:
1. None - No device is attached
2. ACT8XX - External keypad for point of sale