29Configuration Options
Minute for Reboot
General Setup
Used in conjunction with the option Hours to Reboot. The terminal will automatically reboot every X
hours and X minutes.
Monitor Card Prefix
Card Setup
Sets the prefix of the cards to be used on the site.
When Use Monitor Card is enabled in the terminal setup record, only cards with this prefix will be
able to be used on the site.
Multi-pulse Learn Mode
Copier Setup
The terminal is capable of matching different numbers of count pulses coming from an MFD to
separate disbursement extensions. A common example of this is the Kyocera range of copiers,
however the Konica Minolta MFDs are also capable of this mode.
The terminal can be made to only pay attention to number of pulses, or alternatively number of
pulses and exact timing between pulses, depending on the Exact Timing setting.
Out Of Session Count (OOS Count)
General Setup
The terminal is capable of tracking any counts that occur when not in a session. Typically these are
caused by print jobs. As soon as a user begins a session, a transaction is unloaded containing the
following details:
Primary Number - The default disbursement number of the terminal, such as COPIES
Count Items - The number of counts detected whilst not in a normal session
This feature is useful for determining the over-all usage of a multi-function copier without resolving
down to who did the printing.
Paper Feed Time
Copier Setup
The terminal will wait for the paper feed time at the end of a session before unloading the
transaction. This ensures that all pages still in the paper feed path of the copier are accounted for
after the user presses the finish key.
PC IP Address
Setup Tcp/Ip
The address of the server running Supervisor Net. This address is not required if the terminal is
using the Host Name of the server. The host name is set using the IP Terminal Utility. Clearing the
Host Name will cause the terminal to fall back on this address again.
To Next Page
Loading...