Monitor MB206 - Ecopy Multidisb Name; Enable Ecopy; Exact Timing; Gateway Address

Configuration Options24
In a session with Display Balance turned OFF:
In a session with Display Balance turned ON:
eCopy Multidisb Name
eCopy Setup
Defines the disbursement to use when the terminal is invoked by the eCopy system.
See the associated knowledgebase article for further information about this interface.
Enable eCopy
eCopy Setup
Enables the eCopy operation mode. See the associated knowledgebase article for further
information about this interface.
Exact Timing
Copier Setup
Used in multi-pule learning mode. This tells the terminal not to just map number of pulses to
disbursement extensions, but also pay attention to the pulse length and the gap between the pulses,
as differences in timing may indicate different types of copy job.
Gateway Address
Setup Tcp/Ip
The IP Address of the network's gateway. This is ignored if the terminal is using DHCP.
Halt on Error
General Setup
Normally a terminal will simply re-boot if it encounters a fatal error. This setting will cause the
terminal to stop with the details of the fatal error on the screen.
Usually this is used for diagnostic purposes only and should generally be disabled for normal use.