49Configuration Options
fitted, the setting will be ‘All Relays On’, but as there are only two relays currently, it is effectively the
same as setting it to ‘03’. There are five options:
1) 00 = All relays off
2) 01= Relay 1 ON, Relay 2 OFF
3) 02= Relay 1 OFF, Relay 2 ON
4) 03= All Relays ON
5) 15=All Relays ON (see notes)
Timed Item Price
This value * Time units will be charged to the user.
Timed Item Cost
Useful only for the facility owner to calculate the actual cost of doing business. This value is not
used to calculate the charge to the user.
Timed Item Output 01
The same as Count Item Output 01, but for timed item instead of count items.
Timed Item Output 02
The same as Count Item Output 02, but for timed item instead of count items.
Pulse Wait
Appears when ‘Count + 2 Steering’ is selected in the ‘Type’ options. This is the amount of time in
milliseconds the terminal will wait after receiving a count pulse before sampling the steering lines for
a value. This is handy if the photocopier updates the steering line state shortly after issuing a count
pulse.
Latch Input Lines
Preserves the value on the steering lines at the time a count pulse appears for an amount of time set
by the value of the ‘Paper Feed Time’ converted to milliseconds. E.g. if the Paper Feed time is 20,
the steering lines will be latched for 20 milliseconds. This is required if the value on the steering
lines drops away at the same time the count pulse finishes. Under this circumstance, if this feature
is not used, the terminal will always miss the true value of the steering line and the disbursement will
be calculated incorrectly.
To Next Page
Loading...