Sec 2: 8-14 Disassembly/Reassembly Procedures: Radio Disassembly
3. If the RF Board Assembly (F) is to be removed, use the Black Stick to unplug the antenna
coax cable from the RF Board Assembly as shown in Figure 8-19.
Figure 8-19. Remove Antenna Coax Cable Connector
4. Flip the radio over.
8.7.4 Removal of the Main Housing Assembly (D)
• Gently stretch both sides of the Main Housing Assembly (1) outwards to clear the radio.
Then, lift it over the radio as shown in Figure 8-20.
NOTE: Ensure the Belt Clip Cover (39) has been removed.
Figure 8-20. Remove Housing
Antenna Coax Cable Connector
Stretch Outwards
To Next Page
Loading...
