Disassembly/Reassembly Procedures: Radio Disassembly Sec 2: 8-15
8.7.5 Removal of the Back Chassis Assembly (E)
• Back Chassis Assembly (E) has no connections and can be removed by just separating the
the two chassis apart.
Figure 8-21. Remove Back Chassis Assembly from Main Chassis Assembly
8.7.6 Removal of the RF Board Assembly (F)
NOTE: Reconfirm the coax cable connector on the bottom side of the RF Board is
disconnected before removing the RF Board.
1. Unplug the RF Board Assembly (F) from the VOCON Board Assembly (G) by using the Black
Stick. Slowly lift the RF Board Assembly enough to allow access to the small coax cable.
Unplug the small coax cable using a Black Stick or a pair of small tweezers.
Place the RF Board Assembly in a clean and ESD safe area
to avoid contamination to the Battery Connector Seal (35) and
electrical damage to the electronics respectively.
Replace Thermal Pads (33, 34) whenever RF Board
Assembly is removed.
Back Chassis Assembly (17)
Connector
To Next Page
Loading...
