To Next Page

To Previous Page

Advanced Data Formatting 14 - 27

Setup Field(s)

Table 14-1

Setup Field(s) Definitions

Parameter Description Page

Move Cursor

Move Cursor To a Character Scan the

Move Cursor To Character bar code on page 14-28

then any printable ASCII character from the

Alphanumeric

Keyboard

. When this is used, the cursor moves to the position

after the matching character. If the character is not there, the rule

fails and ADF tries the next rule.

14-28

Move Cursor to Start of Data Scan this bar code to move cursor to the beginning of the data.

14-28

Move Cursor Past a Character This parameter moves the cursor past all sequential occurrences

of a selected character. For example, if the selected character is

‘A’, then the cursor moves past ‘A’, ‘AA’, ‘AAA’, etc. Scan the

Move Cursor Past Character bar code on page 14-28

, then

select a character from the

Alphanumeric Keyboard

. If the

character is not there, the cursor does not move (i.e., has no

effect).

14-28

Skip Ahead “N” Characters Scan one of these bar codes to select the desired number of

positions to move the cursor ahead.

14-29

Skip Back “N” Characters Scan one of these bar codes to select the desired number of

positions to move the cursor back.

14-31

Send Preset Value Send prefix and/or suffix value by scanning the appropriate bar

code. These values must be set using the Scan Prefix and Scan

Suffix bar codes on

page 13-4

14-32

Motorola Symbol LS3408 Product Reference Guide

Other manuals for Motorola Symbol LS3408