Symbologies 12 - 31
Interleaved 2 of 5 (I 2 of 5)
Enable/Disable Interleaved 2 of 5
To enable or disable Interleaved 2 of 5, scan the appropriate bar code below, and select an Interleaved 2 of 5
length from the following pages.
*Enable Interleaved 2 of 5
Disable Interleaved 2 of 5
Set Lengths for Interleaved 2 of 5
The length of a code refers to the number of characters (i.e., human readable characters), including check digit(s)
the code contains. Lengths for I 2 of 5 may be set for any length, one or two discrete lengths, or lengths within a
specific range.
One Discrete Length - This option allows the scanner to decode only those I 2 of 5 symbols containing a selected
length. Lengths are selected from the numeric bar codes beginning on page D-1 in Appendix D, Numeric Bar
Codes. For example, to decode only I 2 of 5 symbols with 14 characters, scan I 2 of 5 - One Discrete Length, then
scan 1 followed by 4. In case of an error, or to change the selection, scan Cancel on page D-3.
I 2 of 5 - One Discrete Length
To Next Page
Loading...
