Motorola Symbol LS3408 - Convert All Bar Codes to Code 39; Code 39 Full ASCII Conversion

Scanner Emulation Interface 10 - 7
Convert All Bar Codes to Code 39
Scan the appropriate bar code below to enable or disable the conversion of all bar code data to Code 39.
*Do Not Convert Bar Codes To Code 39
(Disable)
Convert All To Code 39
(Enable)
Code 39 Full ASCII Conversion
By default, any characters that do not have a corresponding character in the Code 39 symbology set are replaced
by a space. If this parameter is enabled, the data sent to the Scanner Emulation Host is encoded in Code 39 Full
ASCII. This setting requires that the Host be able to interpret Code 39 Full ASCII data.
This setting applies only if Convert to Code 39 is also enabled.
*Do Not Convert Code 39 To Full ASCII
(Disable)
Convert Code 39 To Full ASCII
(Enable)