Chapter 13 Miscellaneous Scanner Options
Introduction
This chapter includes commonly used bar codes to customize how the data is transmitted to the host device. In
addition to these bar codes for data formatting, see each host chapter for the appropriate host connections and
host device features for the scanner. See Chapter 12, Symbologies and Chapter 14, Advanced Data Formatting for
customizing data for transmission to the host device.
Before programming, follow the instructions in Chapter 1, Getting Started.
The scanner is shipped with the settings shown in the Miscellaneous Scanner Options Default Table on page 13-2
(also see Appendix A, Standard Default Parameters for all host device and miscellaneous scanner defaults). If the
default values suit the requirements, programming may not be necessary. Features values are set by scanning
single bar codes or short bar code sequences.
Scanning Sequence Examples
In most cases, only one bar code needs to be scanned to set a specific parameter value.
Parameters, such as Prefix Value, require that several bar codes be scanned in the proper sequence. See each
individual parameter for descriptions of this procedure.
Errors While Scanning
Unless otherwise specified, if an error is made during a scanning sequence, re-scan the correct parameter.
To Next Page
Loading...
Need help?
General
