Wand Emulation Interface 9 - 3
Wand Emulation Default Parameters
Table 9-1 lists the defaults for Wand Emulation host types. To change any option, scan the appropriate bar code(s)
provided in the Wand Emulation Host Parameters section beginning on page 9-4.
NOTE See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Table 9-1
Wand Emulation Default Table
Parameter Default
Page
Number
Wand Emulation Host Parameters
Wand Emulation Host Types Symbol OmniLink Interface Controller
9-4
Leading Margin 80 msec
9-5
Polarity Bar High/Margin Low
9-5
Ignore Unknown Characters Enable
9-6
Convert All Bar Codes to Code 39 Disable
9-7
Convert Code 39 to Full ASCII Disable
9-8