Motorola Symbol LS3408 Product Reference Guide

User Preferences 4 - 5
Laser On Time
This parameter sets the maximum time that decode processing continues during a scan attempt. It is
programmable in 0.1 second increments from 0.5 to 9.9 seconds. The default Laser On Time is 3.0 seconds.
To set a Laser On Time, scan the bar code below. Next, scan two numeric bar codes beginning on page D-1 in
Appendix D, Numeric Bar Codes that correspond to the desired on time. Single digit numbers must have a leading
zero. For example, to set a Laser On Time of 0.5 seconds, scan the bar code below, then scan the “0” and “5” bar
codes. In case of an error, or to change the selection, scan Cancel on page D-3.
Laser On Time
Beep After Good Decode
Scan a bar code below to select whether or not the scanner beeps after a good decode. If Do Not Beep After
Good Decode is selected, the beeper still operates during parameter menu scanning and indicates error
conditions.
*Beep After Good Decode
(Enable)
Do Not Beep After Good Decode
(Disable)

Motorola Symbol LS3408 Specifications

General

Brand	Motorola
Model	Symbol LS3408
Category	Scanner
Language	English