Symbologies 12 - 35
Discrete 2 of 5 (D 2 of 5)
Enable/Disable Discrete 2 of 5
To enable or disable Discrete 2 of 5, scan the appropriate bar code below.
Enable Discrete 2 of 5
*Disable Discrete 2 of 5
Set Lengths for Discrete 2 of 5
The length of a code refers to the number of characters (i.e., human readable characters), including check digit(s)
the code contains. Lengths for D 2 of 5 may be set for any length, one or two discrete lengths, or lengths within a
specific range.
One Discrete Length - This option allows the scanner to decode only those D 2 of 5 symbols containing a
selected length. Lengths are selected from the numeric bar codes beginning on page D-1 in Appendix D, Numeric
Bar Codes. For example, to decode only D 2 of 5 symbols with 14 characters, scan D 2 of 5 - One Discrete
Length, then scan 1 followed by 4. In case of an error, or to change the selection, scan Cancel on page D-3.
D 2 of 5 - One Discrete Length
To Next Page
Loading...
