4 - 6 Symbol LS3408 Product Reference Guide
Trigger Mode
The scanner has three trigger modes that can be used to scan bar codes. The desired trigger mode can be set by
using the bar codes below.
Level Trigger
When the trigger is pulled, an aiming dot appears for a programmable duration of time. After this time, the aiming
dot automatically turns into a standard laser scanning beam for a full decode session. The laser scanning beam
stays on until the laser-on timeout occurs, a decode occurs, or the trigger is released. If the trigger is released
before the aiming duration expires, the laser shuts off and no decode occurs.
*Level
Two Stage - Option 1
When the trigger is pulled, an aiming dot appears. This aiming dot remains while the trigger is pulled. When the
trigger is released, the aiming dot automatically turns into a standard laser scanning beam for a full decode
session. The laser scanning beam stays on until the laser-on timeout occurs or a decode occurs. If the trigger is
pulled again while in a decode session, the scanner beam returns to an aiming dot.
Two Stage - Option 1
Two Stage - Option 2
When the trigger is pulled, an aiming dot appears. When the trigger is released, the aiming dot turns off. Pulling the
trigger twice in rapid succession turns on the standard laser scanning beam for a full decode session. The laser
scanning beam, stays on until the laser-on timeout occurs, a decode occurs, or the trigger is released.
Two Stage - Option 2
To Next Page
Loading...
