Motorola Symbol LS3408 Product Reference Guide

8 - 2 Symbol LS3408 Product Reference Guide
Connecting to an IBM 468X/469X Host
This connection is made directly from the scanner to the host interface.
Figure 8-1 IBM Direct Connection
1. Attach the modular connector of the IBM 46XX interface cable to the cable interface port on the scanner. (See
Installing the Interface Cable on page 1-3.)
2. Connect the other end of the IBM 46XX interface cable to the appropriate port on the host (typically Port 9).
3. Ensure that all connections are secure.
4. Select the port address by scanning the appropriate bar code from the Port Address section on page 8-4.
5. To modify any other parameter options, scan the appropriate bar codes in this chapter.
Host Port Connector
Interface cable
NOTE Interface cables vary depending on configuration. The connectors illustrated in Figure 8-1 are examples
only. The connectors may be different than those illustrated, but the steps to connect the scanner remain
the same.
NOTE The only required configuration is the port address. Most other scanner parameters are typically controlled
by the IBM system.

Motorola Symbol LS3408 Specifications

General

Brand	Motorola
Model	Symbol LS3408
Category	Scanner
Language	English