when the configuration has been reset.
Push Buttons Used for configuring the IP address and other parameters.
LEDs
Item Description
Ready Red Indicates that the CN2600 is receiving power
Green Indicates that the CN2600’s OS is ready
Tx Green Indicates serial port transmission
Rx Yellow Indicates serial port reception
LAN 1, LAN 2 Green Ethernet link connection
Off Ethernet cable is disconnected
PWR 1, PWR 2 Red Power connection
Off Power cable is disconnected
Rear Panel
Socket / Port Description
AC Power Input Automatic detection of 100 to 240 V, 47 to 63 Hz AC power supply
DC Power Input Automatic detection of 88 to 300 V
Power On/Off Switch I indicates power on; O indicates power off (AC models only)
Console 8-pin RJ45 RS-232 port for console terminal connection
LAN 1 8-pin RJ45 auto-detectable 10/100 Mbps UTP port
LAN 2 8-pin RJ45 auto-detectable 10/100 Mbps UTP port
Serial Ports 8 or 16 8-pin RJ45 or DB9 ports for DCE modem-type connections
To Next Page
Loading...
Need help?
General
