If you do not include the IP address in the command line, a numbered list of IP addresses for servers currently
installed, along with the total number of ports for each server, will be listed on the screen.
To remove the tty ports for a particular server, type the number next to the server's IP address and then hit
Enter. The following tasks will be performed:
- Modify the npreal2d.cf
- Remove the relevant tty ports in directory “/dev”
- Stop and then restart the driver.
Remove mapped tty ports manually: after entering the directory “/usr/lib/npreal2/driver”, you can modify
“npreal2d.cf” to delete servers and ports manually, and then execute “mxloadsvr” to activate the
modifications.
Removing Linux Driver Files
A utility is included that will remove all driver files, mapped tty ports, and unload the driver. To do this, you only
need to enter the directory /usr/lib/npreal2/driver, then execute mxuninst to uninstall the driver. This
program will perform the following actions:
1. Unload the driver.
2. Delete all files and directories in /usr/lib/npreal2
3. Delete directory /usr/lib/npreal2
4. Modify the system initializing script file.
The UNIX Fixed TTY Driver
Installing the UNIX Driver
1. Log in to UNIX and create a directory for the MOXA TTY. To create a directory named /usr/etc, execute the
command:
# mkdir –p /usr/etc
2. Copy moxattyd.tar to the directory you created. If you created the /usr/etc directory above, then
execute the following commands:
# cp moxattyd.tar /usr/etc
# cd /usr/etc
3. Extract the source files from the tar file by executing the command:
# tar xvf moxattyd.tar
The following files will be extracted:
README.TXT
moxattyd.c --- source code
moxattyd.cf --- an empty configuration file
Makefile --- makefile
VERSION.TXT --- fixed tty driver version
FAQ.TXT
4. Compile and Link
For SCO UNIX:
# make sco
For UnixWare 7:
# make svr5
For UnixWare 2.1.x, SVR4.2:
To Next Page
Loading...
Need help?
General
