Moxa Technologies CN2600 Series - Opening the Web Console

CN2600 Series Configuration with the Web Console
5-4
After adding the CN2600’s IP address as a trusted site, you should be able to view the web console by entering
the CN2600’s IP address in your browser’s address bar.
Opening the Web Console
Open your web browser and enter 192.168.127.254 in the website address line. This is the default IP address
for the CN2600–if a new address has been assigned, enter the new address instead. Press ENTER to load the
page.
ATTENTION
The examples and figures in this chapter use the CN2600 factory default IP address of 192.168.127.254. If you
have assigned a different IP address to your CN2600, be sure to adjust accordingly when following these
directions. Please refer to Chapter 3,
Initial IP Address Configuration, for details on how to configure the IP
address.
3. Enter the console password if prompted. (This will not apply if you did not enable password protection for
your CN2600.) The password will be transmitted with MD5 encryption over the Ethernet.
ATTENTION
If you forget your password, the ONLY way to configure the CN2600 is by using the reset button to reset all
settings and load the factory defaults. If you have disabled the reset button in your
CN2600 configuration, you
may still use it to load the factory defaults within the first 60 seconds that the CN2600 is powered on.
Remember to back up your configuration by exporting it to a file. Your configuration can be easily restored by
importing the
file to the CN2600. This will save time if you have forgotten the password and need to reload the
factory defaults.
4. The CN2600’s web console will appear.