ATTENTION
The Accessible IP List will not be used if you configure the serial port for DRDAS Real COM mode or DRDAS TCP
Server mode. In this case, the Primary IP address, three Backup IP addresses, and filtering method from the
DRDAS configuration will be used.
SNMP Agent Settings
SNMP: To enable the SNMP Agent function, select the Enable option, and enter a community name (e.g.,
public).
Read community string (default=public): This is a text password mechanism that is used to weakly
authenticate queries to agents of managed network devices.
Write community string (default=private): This is a text password mechanism that is used to weakly
authenticate changes to agents of managed network devices.
Contact name: The optional SNMP contact information usually includes an emergency contact name and
telephone or pager number.
Location: Use this optional field to specify the location string for SNMP agents such as the CN2600. This string
is usually set to the street address where the CN2600 is physically located.
SNMP agent version: The CN2600 supports SNMP V1, V2, and V3.
Read-only and Read/write access control
The following fields allow you to define user names, passwords, and authentication parameters for two levels
of access: read-only and read/write. The name of the field will indicate which level of access it refers to. For
example, Read only authentication mode allows you to configure the authentication mode for read-only
access, whereas Read/write authentication mode allows you to configure the authentication mode for
read/write access. For each level of access, you may configure the following:
User name: Use this optional field to identify the user name for the specified level of access.
To Next Page
Loading...
