6. Select Service. Verify that the RADIUS ports assignments match your configuration.
[Authentication] 1645 or 1812
[Accounting] 1646 or 1813
7. Select Client, and then click Add. Enter the CN2600’s IP address in the IP address field. Enter the CN2600’s
RADIUS key in the password field. This must match the RADIUS key that you set in the CN2600 console.
8. Click Apply.
9. Right click RADIUS in the left information window, and select Start. You will now see that RADIUS is
running.
Setting up Windows 2000 Hosts
1. Open Start
Routing and Remote Access.
2. Right click Server (Local) and select Configure and Enable Routing and Remote Access. Click Next
to continue.
3. Select Remote access server and click Next to continue.
To Next Page
Loading...
