Moxa Technologies CN2600 Series - Telnet Console

CN2600 Series Initial IP Address Configuration
3-4
11. Execute the arp -s command from your computer’s MS-DOS prompt as follows:
arp -s <IP address> <MAC address>
For example,
C:\> arp -s 192.168.200.100 00-90-E8-04-00-11
12. Next, execute a special Telnet command by entering the following exactly:
telnet 192.168.200.100 6000
When you enter this command, a Connect failed message will appear, as shown below.
13. After the CN2600 reboots, its IP address will assigned to the new address and you can reconnect using
Telnet to verify that the update was successful.
Telnet Console
Depending on how your computer and network are configured, you may find it convenient to use network
access to set up your CN2600’s IP address. This can be done using Telnet.
ATTENTION
Figures in this section were taken from the CN2600’s Telnet console.
1. From the Windows desktop, select Start

Run, and then type telnet 192.168.127.254 in the Run
window (for LAN 1) or telnet 192.168.126.254 (for LAN 2).
If your IP address is different from the default setting, use your IP address instead. Click OK.
2. The console terminal type selection is displayed as shown. Enter 1 for ansi/vt100 and press ENTER to
continue.
3. Press N or use the arrow keys to select Network, and then press ENTER.