SHOP MANUAL MT26-31 - 06.2005
Engine
Tier-3 710655-
Ch 1 page 134
1. Front cover
2. Gasket
3. Pump cover
4. Shaft with bearing
5. Sealing ring
6. Impeller
7. Pulley
8. Guide sleeve
9. Flange screw
10. Flange screw
1.
Drain the cooling system through the drain
taps in the block and in the pipe from the
outlet on the radiator.
2.
Remove any protection meshes and fan ring
with sealing ring to gain access to the fan.
3.
Remove the fan.
4.
Turn the automatic belt tensioner and prise
the poly-V-belt off the coolant pump pulley.
5.
Remove the coolant pump assembly.
Fitting the pump
1.
Clean old gasket debris from the sealing
surfaces.
2.
Fit the pump without damaging the seal(s).
3.
Fit the automatic belt tensioner.
4.
Fit the (poly-V) drive belt and any protection
mesh and fan ring with sealing ring.
5.
Fit the fan.
6.
Fill the cooling system. See booklet 00:03-01
for the composition of the coolant.
7.
Start the engine and check that no leakage
occurs. Check the level of the coolant and top
up as necessary.
Removing
To Next Page
Loading...