Moxy MT 26 - Flash Codes Tables

Engine
SHOP MANUAL MT26-31 - 06.2005
Tier-3 710655-
Ch 1 page 35
This is a list of the flash codes which can be read and the fault codes to which they correspond.
One flash code in ECU S6 corresponds to several different fault codes.
Flash codes tables
Flashing code lis t for the EMS c o n t r o l unit
Code Description
Code
Description
0
No fau lt detected.
53
PDE in cylinder 3: The solenoid valve does not
work c orrectly.
11
Overspeed. One or both engine speed
sensors are displ aying speeds in excess of
3000 r/mi n.
54
PDE in cylinder 4: The solenoid valve does not
work c orrectly.
12
Engine speed sensor 1 faulty, or incorrect
signal.
55
PDE in cylinder 5: The solenoid valve does not
work c orrectly.
13
Engine speed sensor 2 faulty, or incorrect
signal.
56
PDE in cylinder 6: The solenoid valve does not
work c orrectly.
14
Coolant temperature sensor faulty, or
incorrect signal.
57
PDE in cylinder 7: The solenoid valve does not
work c orrectly.
15
Charge air temperature sensor faulty, or
incorrect signal.
58
PDE in cylinder 8: The solenoid valve does not
work c orrectly.
16
Charge air pressure sensor faulty, or incorrect
signal.
59
Incorrect signal in extra analog input.
17
Oil temperature sensor faulty, or incorrect
signal.
61
Incorrect control unit shutdown.
18
Oil pressu re sensor faulty, or incorrect signal.
66
Shutdown due to coolant level
21
Coolant level sensor f a u l t y .
68
Alternator charging incorrectly.
23
Fault cod e internally in the coordinator.
69
Starter mot or function interrupted or not
activated.
24
Accelerator/brake. If the acc el erator and brake
have been operated simultaneousl y.
82
Engine speed above r ef. speed at start
25
Accelerator sensor/idling switch
Accelerator sensor/kick-down switch
83
Fault in memory circuit (EEPROM) in co ntrol
unit.
27
Engine shutdown bypassed.
84
Data trans fer to the control unit memory
(EEPROM) has been interrupted.
28
Shutdown due to oil pressure
85
Incorrect temperature internally in the control
unit.
31
Torque limitation due to oil pressure
86
Internal fau lt in the control unit: Fault in
hardware control.
32
Incorrect pa r a m e t e r s for limp home functi on.
87
Fault in control unit RAM.
33
Battery v oltage incorrect or no signal.
88
Internal c ontrol unit fau lt: Memory f ault
37
Emergency shutdown switch activated in
accordance with CAN message from
coordinator.
89
Incorrect seal: Illeg a l editing of software.
43
CAN circuit faulty in the cont rol unit.
93
Engine speed sensor s faulty or not connected.
47
Immobiliser f u n c t i o n. Ignition key code
incorrect.
94
Shutdown due to high c oolant
temperature.
48
There is an incorrect CAN messag e or no
CAN message from the coordinator.
96
Torque limitation due to high
coolant temperature.
49
Incorrect CAN version in control unit or
coordinator.
98
Incorrect voltage supply to one of the sensors.
51
PDE in cy linder 1: The solenoid valve does not
work corr ectly.
99
Internal hardware faul t in the processor (T PU).
52
PDE in cy linder 2: The solenoid valve does not
work corr ectly.