SHOP MANUAL MT26/31 - 08.2006 SHOP MANUAL MT26/31 - 08.2006
SHOP MANUAL MT26/31 - 08.2006 SHOP MANUAL MT26/31 - 08.2006
TRANSMISSION
Ch 2 page 44
Find the diagnostic contact (607) between the controller units
NOTE !
Before starting the AEB, the transmission-oil
must have a temperature at 70 - 80°C
1 Connect the plug from AEB starter to the diagnostic
contact without the ignition on.
2 Turn on the ignition.
3 Start the engine.
Note:
AEB will not start with any fault codes on
display except fault „F6“
1 The engine running and the brake on
2 Push the button for AEB start
If malfunction the ignition had to turn off and stop the
engine. Turn the ignotion on, and start the engine again.
The display show the
action
(Display message)
If successfully , the disblay showing OK
See the table next page
To Next Page
Loading...