Engine
SHOP MANUAL MT26-31 - 06.2005
Tier-3 710655-
Ch 1 page 49
10.
Remove the fork clamp bolt holding the unit
injector in place.
11.
Detach the cables on the unit injector. The
screws cannot be removed but undo them as
far as possible.
Note:
Do not lift the unit injector by the spring.
The spring can come loose.
12.
Turn the unit injector anti-clockwise until it
stops. Place the slide hammer 87 596
between the solenoid valve and the edge of
the lower rocker cover as illustrated.
Note:
If the slide hammer is placed
directly under the solenoid valve,
there is a risk of breaking the
solenoid valve.
Place the slide hammer as indicated by
the arrow.
1. Fork clamp
2. Fork clamp bolt
3. Unit injector
To Next Page
Loading...