MSENSE
®
DGA 9 7045899/02 EN – 11.2020 Page 119
• Ignore echo check boxes & select RTS transmit control according to the adapter specification
• General settings: Enter the correct address (own Bus address)
RS485 Bus Bridge
The RS485 bus bridge is an extension that allows communication with an RS485 network in which
several MSENSE® DGA 9 devices are present. In this configuration, the host PC is connected via a
modem or RS232 to a MSENSE® DGA 9 device, which serves as a communication gateway.
The settings correspond exactly to those of the RS485 bus node settings, but with one exception:
The device with the gateway function must be in the Bus communication settings in “Bus bridge”
mode.
Bus Bridge / Gateway Device Settings
To Next Page
