mru NOVAplus - Measurement Settings Configuration

USER MANUAL NOVAplus
MRU GmbH, D-74172 Neckarsulm 31 / 95
5.3. Measurement settings
Explanation for “Helping hints”:
Some helpful hints which are very useful for an inexperienced user but
are not needed by experienced users, can be activated or deactivated.
The following hints will be affected:
“Zeroing finished, Sensors are ready. Analyzer ready for measurement.”
“Reminder! Charge batteries at regular intervals!”
“Measurement stopped/started.”
Gas cooler mode
Full / Eco
full: cooling up to approx. + 5 °C
eco: cooling up to approx. 10 °C below ambient tem-
perature (not under +5 °C!)
Probe heating
as needed / with
mains
Probe heating is always switched on with mains, if the
NOVAplus is connected to mains and is switched ON.
Temperature unit
°C or °F
Change the unit for temperature in all screens
Pressure unit
hPa/PA, hPa, kPa/Pa,
kPa, mbar, mmH2O,
cmH2O,
inchH2O,mmHG,
inchHG, PSI, Pa
Change the unit for pressure in all screens. The mean-
ing of hPa/Pa and kPa/Pa is that the instrument per-
forms a dynamic change of unit depending on the
absolute value of pressure.
Core flow search
ON / OFF
Core flow search before start of each flue gas meas-
urement: activated or deactivated
Input soot & T-Boiler
ON / OFF
Input soot and T-boiler values for print-outs and/or
storage: activated or deactivated
Annular-gap test
ON / OFF
Annular-gab meaasurement: activated or deactivated