mru NOVAplus - Test Program

USER MANUAL NOVAplus
MRU GmbH, D-74172 Neckarsulm 50 / 95
For this measurement MRU offers an annular gap probe (Part no. 56352)
which can be connected to the condensate separator of the analyzer.
Optional you can connect the annular gap probe with an adaptor (Part
No. 11652) to the tip of the probe pipe.
Test program
This test program is made for testing facilities that will test these analyz-
ers with test gases and don’t need to make any modifications. In this
program you will only see measured values and no calculated values at
all.
► Go to the Measurement menu.
► Select Flue gas measurements.
► Press OK.
 The menu Selection meas. program appears.
► Select Test program
► Press OK.
 The menu Test program appears.
, ,
Select Annular gap measurement
F1
Start Annular gap measurement
F3
Draft measurement and annular-gap tempera-
ture measurement is determined on the 2nd
measuring step with the standard probe
F2
Save measured values
ESC
Back to the measurement menu without saving