USER MANUAL NOVAplus
MRU GmbH, D-74172 Neckarsulm 91 / 95
RCU:
Please write down your Firmware-Version
(e.g. 1.11.50)_________________________________
Please write down your serial number
(e.g. 012072)____________________________
Base unit:
Please write down your Firmware-Version
(e.g. 1.09.01_____________________________
Please write down your serial number
(e.g. 012039)____________________________
Do the following steps in order to update the firmware:
► copy the files '1093Base.fwb' and '1093RCU.fwb' to a SD card in the
root directory (that means in no directory), in case you received the
files in a zip archive you'll have to decompress it first
► switch on the analyser (Base and remote control) and verify whether
the connection is OK (blue symbol)
► insert the SD card into the remote control
► you will be asked: 'Firmware for base found. Install now?'
► acknowledge with 'install'
► the base update will be started and will take about 1 minute, while
you will here several beeps
► then you will be asked: 'Firmware for remote control found. Install
now?'
► acknowledge again with 'install'
► the remote control update will be started and will take about half a
minute, while the display remains empty
► finished
How do I identify if the update was successful?
► Switch on the analyzer.
► Go to the Extras menu
► Select Device info.
In the first line the new firmware version must be displayed
To Next Page
Loading...
