Multilin SR469 - Voltage Metering; Speed

A2 METERING DATA 5. ACTUAL VALUES
5-10
5.3.3 VOLTAGE METERING
y
92/7$*(#0(7(5,1*
y
>(17(5@#IRU#PRUH
Õ
ÕÕ
Õ
ENTER
ENTERENTER
ENTER
ESCAPE
ESCAPEESCAPE
ESCAPE
Ö
ÖÖ
Ö 9DE=#####3#9EF=####3
9FD=#####3#9ROWV
RANGE: 0 - 20000
NOTE: This message is not seen if VT Connection is programmed as ‘None’
Û
ÛÛ
Û
ESCAPE
ESCAPEESCAPE
ESCAPE
MESSAGE
MESSAGEMESSAGE
MESSAGE
Ú
ÚÚ
Ú
$9(5$*(#/,1(
92/7$*(=###3#9ROWV
RANGE: 0 - 20000
NOTE: This message is not seen if VT Connection is programmed as ‘None’
Û
ÛÛ
Û
ESCAPE
ESCAPEESCAPE
ESCAPE
MESSAGE
MESSAGEMESSAGE
MESSAGE
Ú
ÚÚ
Ú
9DQ=#####3#9EQ=####3
9FQ=#####3#9ROWV
RANGE: 0 - 20000
NOTE: This message seen only if VT Connection is programmed as ‘Wye’
Û
ÛÛ
Û
ESCAPE
ESCAPEESCAPE
ESCAPE
MESSAGE
MESSAGEMESSAGE
MESSAGE
Ú
ÚÚ
Ú
$9(5$*(#3+$6(
92/7$*(=###3#9ROWV
RANGE: 0 - 20000
NOTE: This message seen only if VT Connection is programmed as ‘Wye’
Û
ÛÛ
Û
ESCAPE
ESCAPEESCAPE
ESCAPE
MESSAGE
MESSAGEMESSAGE
MESSAGE
×
××
×
6<67(0#)5(48(1&<=
##3133#+]
RANGE: 0.00, 20.00 - 120.00
DESCRIPTION:
Measured voltage parameters will be displayed here.
If no VT connection type is programmed in S2 SYSTEM SETUP, the following flash message will appear when an attempt is made to
enter this group of messages.
7+,6#)($785(##127
352*5$00('
5.3.4 SPEED
y
63(('
y
>(17(5@#IRU#PRUH
Õ
ÕÕ
Õ
ENTER
ENTERENTER
ENTER
ESCAPE
ESCAPEESCAPE
ESCAPE
Ö
ÖÖ
Ö 7$&+20(7(5=###3#530
RANGE: 0-3600
NOTE: This message seen only if a Digital Input is configured as Tachometer
DESCRIPTION:
If the Tachometer function is assigned to one of the digital inputs, the tachometer readout may be viewed here.
If no digital input is configured as tachometer in S3 DIGITAL INPUTS the following flash message will appear when an attempt is made
to enter this group of messages.
7+,6#)($785(##127
352*5$00('