Multilin SR469 - Page 264

SR469 MANUAL
INDEX
#
0-1mA 2-12, 4-67, 4-69
0-20mA 4-69
4-20mA 2-12, 4-67, 4-69
A
acceleration 5-15
acceleration timer 4-45
access switch 4-14
actual value message map 5-1
actual values 5-1
alarm relay 2-16
alarm status 5-5
alarms 4-1, 5-23
ambient RTD 4-52
analog input 2-12, 5-17
analog I/P min/max 4-8
analog in diff 1-4 4-70
analog in diff 3-4 4-71
analog in min/max 5-17
analog input minimums and maximums 4-14
analog inputs 1-4 4-69
analog inputs and outputs 7-6
analog output 2-12
analog outputs 1-4 4-67
test analog output 4-75
apparent power demand 5-12
assignable digital inputs 4-15
auxiliary relay 2-16
average motor load 4-5, 5-15
B
baud rate 6-1
bearing RTD 4-50
block start 4-1
C
calibration info 5-22
capture trace See digital input functions
clear data 4-8
comm port monitor 4-76
configuration 8-3
control power 2-8
cooling time constants 4-25, 4-36
core balance 4-10
CRC-16 6-3
current demand 4-65, 5-12
current metering 5-8
current sensing 4-10
current unbalance 4-42
custom curve 4-30
custom overload curve 4-27
cyclic redundancy check See CRC-16
D
data frame format 6-1
data packet format 6-2
data rate 6-1
default message 4-5
default messages 4-6
demand 4-65, 5-12
demand data 4-14
demand period 4-66
device number 1-1
diagnostic messages 5-23
dielectric strength testing 2-19
differential 4-44
differential CT primary 4-10
differential current inputs 2-10
digital counter 4-8, 4-14, 5-19. See digital input functions
digital input functions
capture trace 4-21
digital counter 4-19
general switch A-D 4-21
load shed trip 4-17
pressure switch alarm 4-17
pressure switch trip 4-18
remote alarm 4-15
remote trip 4-16
simulate fault 4-21
simulate pre-fault 4-21
simulate pre-fault...fault 4-21
speed switch trip 4-16
tachometer 4-20
vibration switch alarm 4-18
vibration switch trip 4-18
digital inputs 2-11, 5-7, 7-6
dimensions 2-1
display 3-2
drawout indicator 2-17
E
emergency restart 4-14
emergency restarts 4-9, 4-14
entering +/- signs 3-4
entering alphanumeric text 3-4
error checking 6-3
error responses 6-14
estimated trip time on overload 5-2
event record 4-8, 4-14
event recorder 5-20, 6-15
F
faceplate 3-1
fault setup 4-74
flash messages 5-24
flow 2-12
frequency 4-56
G
general counters 5-19
general switch A-D See digital input functions
ground and differential accuracy test 7-3
ground CT 4-10
ground current 5-8
ground current input 2-9
ground fault 4-43
H
high inertia load 4-24
high inertial load 4-31
hipot 2-19
hot/cold curve ratio 4-37
hp 5-11